Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KEHS01PMT0 > Parts

KEHS01PMT0 KitchenAid Dryer - Parts

All parts for the KitchenAid Dryer KEHS01PMT0

Below is a list of all parts for the KitchenAid Dryer KEHS01PMT0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KEHS01PMT0
15-28 of 177
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$9.95

Light Bulb - 10W

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

$7.39

Electrode, Sensor

$24.28

Idler Pulley with Bracket

$32.12

Dryer Drum Seal with Adhesive

This drum seal with a silicone rubber adhesive is used in dryers. This part seals the drum to make sure air does not escape from the dryer. If your dryer is making loud noises, is not producing enough heat, or no heat at all, or there are marks left on your clothes, replacing the seal on your dryer can solve the problem. The tools needed for this installation project are: 1/4 inch nut driver, Phillips screwdriver, small flat blade screwdriver, and putty knife. Remember to unplug your dryer from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for installation instructions.

$3.02

Cover Screw

Sold individually.

$6.18

Screw, 10-16 x 1

This screw is sold individually.

$37.64

Wheel, Blower

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic...

$27.03

Drum Support Shaft - Left Hand Threads

This shaft is for the front with left hand thread. Sold individually.

$4.53

Catch, Door Assembly (1)

This white female door catch is attached to the dryer door.

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$34.95

Motor Pulley

$27.42

Drum Roller Shaft - Right Hand Threads

This front shaft with right hand threads is used in dryers. The shaft and the drum support rollers ride on to support the drum. If your shaft has flat spots and the rollers do not spin, replacing the shaft can solve the problem. The tools needed for this repair are: 5/16 inch socket or nut driver, 1/4 inch socket or nut driver, small flathead screw driver, channel-lock pliers, 9/16 inch socket. Remember to unplug your appliance from the power source before beginning this installation project. Refer to the diagram provided by the manufacturer for further installation instructions.

$53.23

High Limit Thermostat - L295-50F

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to t...

$4.63

Single Access Panel Spring Retainer/Clip

Sold Individually.

All Parts for the KEHS01PMT0
15-28 of 177