Models > KECT305XWH0

KECT305XWH0 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KECT305XWH0

If you know the cooktop repair part you need, you can browse the list of all parts on the KECT305XWH0, or you can search by name or part description. You can also find your part by where it is located on the KECT305XWH0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KECT305XWH0 [Viewing 2 of 2]

$23.61

Burner Switch Kit

This push-to-start Robertshaw style replacement for load rated switches has a clockwise rotation. It also has a break off shaft, and comes with plastic adapters.

$85.05

Solid Surface Burner - 8"

$67.82

Solid Surface Burner - 6"

Burner Knob - Black

Sold individually.

SCREW

TRIM-RING

TRIM-RING

TRIM-RING

SEAL-SLCNE

TRIM-RING

Common Symptoms of the KECT305XWH0 [Viewing 1 of 125]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner would not heat

  • Customer: Edward from Malvern AR
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 18 of 24 people found this instruction helpful
First i shut off the power since this is an electric cook top/range. I then removed the knob and the two screws that hold the burner switch in place. I removed the wires one at a time and connected each to the new switch. I then reattached the screws to the switch. The most difficult part to me was breaking off the switch stem at the right level. I got ... read more

burner quite heating discovered switch was the problem

  • Customer: Ronald from McClelland IA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 7 people found this instruction helpful
lifted hood top unscrewed 4 small screws opening lid to switch housing took out 2 small screws that held the switch and then transfered wires to new switch replaced new switch with 2 new screws and back to working again walla! Time spent less than 30 minutes very simple as the instructions were very self explainatory. read more

The switch had shorted

  • Customer: Stephen from COlleyville TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 5 of 8 people found this instruction helpful
I reviewed the schematic. Removed the outer casing. Pulled out the existing wires and replaced them exactly on the new switch. Snipped out off the control stem to match the others. There was a small metal piece on the old stem which holds on the knob. I removed it from the old stem and put it on the new stem and Eureka. read more