Models > KECC507RSS05

KECC507RSS05 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KECC507RSS05

If you know the cooktop repair part you need, you can browse the list of all parts on the KECC507RSS05, or you can search by name or part description. You can also find your part by where it is located on the KECC507RSS05 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KECC507RSS05 [Viewing 1 of 1]

$61.68

Surface Ribbon Element with Limiter - Small

This is a 1500 watt surface element.

$74.00

Surface Element - 1200W

$2.70

SCREW

This screw is sold individually.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$10.48

Main Power Terminal Block

$3.84

SCREW

Sold individually.

$151.73

Surface Element with Limiter - Left Front

$120.05

Infinite Switch - Triple Element

$2.70

SCREW

$296.13

Cooktop Glass - Black

Common Symptoms of the KECC507RSS05 [Viewing 1 of 186]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Hot Burner Light always on

  • Customer: Gregory from Cary NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 42 of 62 people found this instruction helpful
Thermal switch is integral to element and can not be changed, must replace entire element.

Turn off power. Removed front two screws above oven door jamb and lifted the top. Removed the bracket that holds the element against the glass top and removed the element. Moved brackets from old element to new one, aligning to same numerical position and th... read more

Loose terminal caused block to overheat and break

  • Customer: Dana from Black Mountain NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 5 of 8 people found this instruction helpful
Removed all terminals and block mounting screws. Repaired one burnt terminal and reassembled. Replacement part was an exact fit and reassembly whnet very well. read more

I snapped a bolt on the main power terminal block when connecting the pigtail.

  • Customer: Frank from Palm Coast FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 3 of 4 people found this instruction helpful
Removed the small metal panel covering the main power terminal in back of the electric range. Removed the nuts holding the red, white and black electrical wires from the range using the appropriate socket (there will be two nuts on each bolt end). Removed the two screws holding the main power terminal block with appropriate screw driver. Connect the new main... read more