Models > KECC501GAL2

KECC501GAL2 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KECC501GAL2

If you know the cooktop repair part you need, you can browse the list of all parts on the KECC501GAL2, or you can search by name or part description. You can also find your part by where it is located on the KECC501GAL2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KECC501GAL2 [Viewing 1 of 1]

$15.74

Surface Burner Knob

Sold individually.

$109.18

Large Surface Element - 2500W

$74.00

Surface Element - 1200W

$89.84

Surface Burner Element - 1800W

$8.44

USE MCN TJ114

$61.68

Surface Ribbon Element with Limiter - Small

This is a 1500 watt surface element.

$16.68

Burner Knob

Sold individually. This knob accepts a double-flat shaft.

$40.49

6" Surface Element Infinite Switch

$3.83

SCREW

$3.42

Switch Seal

Common Symptoms of the KECC501GAL2 [Viewing 1 of 433]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Right Front Surface Element would not heat

  • Customer: Robert from Blackwood NJ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 40 of 45 people found this instruction helpful
Turn off the power to the Electric Oven.
Remove the 2 screws to the oven top at the front of the stove. Lift the oven top up. Have someone hold it for you. Label the wires that go to the element you are going to replace. Disconnect the wires from the Element. Remove the screw from the bracket that holds the front and rear element in place. It is located... read more

Hot Burner Light always on

  • Customer: Gregory from Cary NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 36 of 53 people found this instruction helpful
Thermal switch is integral to element and can not be changed, must replace entire element.

Turn off power. Removed front two screws above oven door jamb and lifted the top. Removed the bracket that holds the element against the glass top and removed the element. Moved brackets from old element to new one, aligning to same numerical position and th... read more

the 2500 watts element-surf was opened (wasn't heating)

  • Customer: luis from Lincoln NE
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 16 of 18 people found this instruction helpful
1 Turn the circuit breaker that feds power to the range/stove off
2 Opened the oven door and found two screws that hold the top part of the range. I removed the screws and disconnected the green cable (ground) so I could have access to the Element-surt
3 Disconnected the four wires that connects the Element and removed the braket that holds it.read more