Models > KEBI200YBL2

KEBI200YBL2 KitchenAid Oven - Overview

Get Parts and Repair Help for KEBI200YBL2

If you know the oven repair part you need, you can browse the list of all parts on the KEBI200YBL2, or you can search by name or part description. You can also find your part by where it is located on the KEBI200YBL2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for KEBI200YBL2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$18.07

2 Piece Broiler Pan

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$4.46

Light Gasket

$37.80

Inner Door Glass

Frame is no longer available.

$45.37

Oven Rack

$28.80

SOCKT-LITE

$45.11

Bake Element

This bake element is found on the bottom of the oven. It has push-on terminal ends.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 89 of 114 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Broken oven door inner glass

  • Customer: Michael from Commerce Township MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 20 people found this instruction helpful
I first removed the two screws (located on the inner side of the door about halfway from the top) which hold the hinges to the door. With the screws removed, I was able to remove the entire door by grasping the door on each side and puling up and sliding the door away from the hinges.

The rest involves deconstructing the door by removing the scre... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more