Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KDRP407HSS10

KDRP407HSS10 KitchenAid Range - Overview

Get Parts and Repair Help for KDRP407HSS10

If you know the range repair part you need, you can browse the list of all parts on the KDRP407HSS10, or you can search by name or part description. You can also find your part by where it is located on the KDRP407HSS10 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for KDRP407HSS10 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Manuals & Care Guides for KDRP407HSS10

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$55.86

Inner Door Glass

This inner door glass is a heat resistant part that fits into a stove, oven, wall oven, cooktop, or range as the inner glass panel of the appliance door. The glass panel allows you...

$3.02

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

$4.12

Torx Screw

7-18 x 3/4" - sold individually.

$25.98

Halogen Light Bulb - 5W 12V

This broil element, located at the roof of the oven, has push on terminals. The element supplies heat to the oven. If there is little to no heat when broiling and baking, or the element does not heat, replacing the broil element can be a solution. This part is around 12 inches wide and 19 inches long. To replace it, pull the oven door from hinges after removing screws. Next, remove the screws holding the elements in place and pull off wires attached to the back of the element. To finish off, add new element and screw it back in place. Remember to unplug the oven from the power source before beginning this installation.

$66.80

Temperature Sensor

The temperature sensor measures the temperature inside the oven. If your oven is too hot, not heating evenly, is not heating enough when baking, or simply will not start, you could...

$39.82

Limit Thermostat

An oven thermostat is a switch that opens and closes in response to the temperature it senses. It is typically found in the control panel, where a liquid-filled temperature-sensing bulb senses and maintains the internal oven temperature by cycling heat on and off. This safety thermostat trips when the controls are not working properly, or if the range gets too hot. If your oven will not start or is not heating properly, there could be an issue with the limit thermostat, and you should look to replace the part. NOTE: Remember to disconnect the power from your range before you start this repair. This is an electrical appliance that can potentially hold a 220 volt charge.

$50.17

Broil Element

This broil element is found on the roof of the oven.

$188.78

Exterior Door Glass - Stainless

Exterior portion only. Not the entire door assembly.

$2.96

Screw

Sold individually.

$56.49

Inner Door Glass

Glass only.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broke the glass panel inside the oven door -- dropped a baking dish on the glass!

  • Customer: Robert from Wildwood, MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 160 of 199 people found this instruction helpful
Easily removed the door from the oven by releasing clips attached to the door hinge -- very nicely engineered. Removed about 6 philips head screws to allow the door assembly to be taken apart for access to the glass. Lifted out the broken glass, cleaned the inside of the door, installed the new glass, reassembled the door (a two minute project), and reatt... read more

No heat after cleaning oven

  • Customer: Frederick from St. Louis, MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 98 of 107 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

Cracked the inner door glass by wiping with wet rag when hot

  • Customer: James from Renton, WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 42 of 49 people found this instruction helpful
Removed the oven door by following the straightforward instructions in the user's manual. Removed philips head screws to take the door assembly apart. Removed clips holding the two inner door glass plates, and the two plates. Removed the clamp holding the broken glass plate, then the glass and associated glass fragments. Then cleaned and re-installed the... read more