Models > KDDT207BWH1

KDDT207BWH1 KitchenAid Range - Overview

Get Parts and Repair Help for KDDT207BWH1

If you know the range repair part you need, you can browse the list of all parts on the KDDT207BWH1, or you can search by name or part description. You can also find your part by where it is located on the KDDT207BWH1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for KDDT207BWH1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.25

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$4.46

Knob Skirt

$18.07

2 Piece Broiler Pan

$3.96

Glass Top Knob Skirt

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$2.70

Cover Screw

Sold individually.

$4.46

Light Gasket

$18.29

Control Knob

Sold individually. This knob accepts a D-shaped shaft.

$14.12

Control Knob

Sold individually. This knob can accept a D-shaped shaft.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 91 of 116 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Sparker would not quit sparking after lighting the gas.

  • Customer: John from Waterford MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Wrench(Adjustable)
  • 20 of 24 people found this instruction helpful
Turned off the gas then disconnected the gas line. Unplugged the AC cord and removed the unit from the counter top. Had to locate a suitable area to lay the cooktop, rather large. The bottom cover is held on by 6-8 sheet metal screws, however, the gas regulator and nipple must be removed also for the cover to come off. I removed the Igniter module screws, le... read more

Broken oven door inner glass

  • Customer: Michael from Commerce Township MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 20 people found this instruction helpful
I first removed the two screws (located on the inner side of the door about halfway from the top) which hold the hinges to the door. With the screws removed, I was able to remove the entire door by grasping the door on each side and puling up and sliding the door away from the hinges.

The rest involves deconstructing the door by removing the scre... read more