This tray rotates in your microwave ensuring more even temperatures. It is used to hold containers and plates of food or beverages that you heat up inside of the appliance. If you notice that the tray...
In your microwave, the diode allows current to flow one-way only, converting alternating current to direct current. If you notice that your microwave does not heat properly, you may need to replace th...
This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the m...
This screw is for microwaves.
A qualified technician should install this part if it requires accessing internal components of the microwave or microwave door. High-voltage capacitors can retain a l...
After shopping all over town trying to find a new tray I discovered PartSelect.com, I called and ordered the tray and received it the next afternoon. It couldn't have gone smoother.
The reason the door would not open upon pressing the door opener is because the BRCKT-LATCH was broken. I discovered that after opening the microwave enclosing. The BRCKT-LATCH has two ends sticking out....each fits into a hole. One of the ends on the LATCH was broken and therefore it was not tightly fit. No upon pushing the door opener t
... Read morehe LATCH would not function properly since it was loosely fit and hence the door would not open. To Fix this issue: 1) Buy a new BRCKT-LATCH 2) Remove the microwave enclosing. I had to use a special screwdriver, since the screws were security protected on my microwave. After removing the case, I opened the door by manually pressing the door latch upwards (please make sure that the microwave is not connected to the electric socket before removing the enclosing). 3) pull out the old LATCH from the microwave. 4) carefully insert the new LATCH. Try not to put too much pressure when trying to fit the latch, or else the ends may snap again!! 5) Close the door and try opening it by pressing the door opener. it should work now!!