Models > KCMS125YBL0

KCMS125YBL0 KitchenAid Microwave - Overview

Get Parts and Repair Help for KCMS125YBL0

If you know the microwave repair part you need, you can browse the list of all parts on the KCMS125YBL0, or you can search by name or part description. You can also find your part by where it is located on the KCMS125YBL0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$44.27

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$3.96

Button Return Spring

This spring is located behind the release button on microwaves.

$52.96

Glass Cooking Tray

$22.47

DIODE

$4.64

SCREW

$19.50

SPRAY

$59.10

High-Voltage Capacitor - 2100V 50/60Hz .95Uf

$7.64

BULB-LIGHT

$191.75

Magnetron with Screws

This part is used to generate microwave energy/heat.

Common Symptoms of the KCMS125YBL0 [Viewing 1 of 15]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 29 of 35 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

Close the door on the microwave, punch in the # nothing happened

  • Customer: Robert S. from Stafford TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 12 people found this instruction helpful
I removed the unit from the wall. Took the cover off. Set the unit on its side. It revealed the working parts. Removed the old micro switches. Put in the new oness. Presto, it worked. Very easy for me.
The parts was delivered almost before my notice they were shipped. read more

Fan motor and magnetron did not come on, but every thing else did.

  • Customer: Dale from Chester CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 4 of 6 people found this instruction helpful
Problem would come and go. Found service schematic inside unit. Perform all the suggested tests. One possible solution was the primary interlock switch shown on the schematic and a check found the switch stuck. It would free up some times but would stick again in the open position. Ordered switch which was a simple plug in unit. read more