Models > KCMG125EBU0

KCMG125EBU0 KitchenAid Microwave - Overview

Get Parts and Repair Help for KCMG125EBU0

If you know the microwave repair part you need, you can browse the list of all parts on the KCMG125EBU0, or you can search by name or part description. You can also find your part by where it is located on the KCMG125EBU0 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$135.59

Microwave Magnetron

This part is used to generate microwave energy/heat.

$47.58

PAN-CRISP

$33.56

TRAY-COOK

$56.13

CAPACTR-MG

RACK

$10.37

HANDLE-PAN

$9.77

Ceramic Fuse

20 Amp.

LAMP-INCANDESCENT

$25.39

COVER-PLT

$210.11

TRANSFORMR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven buzzed and no heat

  • Customer: Joseph from Saint Charles IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 34 of 39 people found this instruction helpful
First took down the hood/microwave and removed the sheet metal housing.
I changed HV diode as it was the least expensive component and the first one that internet suggested and tested bad with a ohm meter. Didn't fix a thing.
Capacitor failed test with meter so I ordered and then replaced this.
Still no change so I ordered a new magnetron. ... read more

Microwave went dead while in use.

  • Customer: Keith from Georgetown TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 20 of 24 people found this instruction helpful
1. removed vent across the top to gain excess to Screw holding control in place. 2. Removed control panel to access Fuse. 3. Remover fuse after pulling plug. 4.Tested fuse for continuity with volt ohm meter noting no continuity.5. Orderd new fuse. 6. receeived new fuse and installed infuse holder.7. plugged microwave plug back in receptical and tested unit n... read more

My microwave began suddenly making a loud humming noise while cooking food.

  • Customer: Lindsay from Nampa ID
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 65 of 175 people found this instruction helpful
My microwave began suddenly making a loud harsh humming noise while cooking food. I did not let it go on long enough to know if it cooked the food or not. I did some Internet research and learned that it was likely the Magnetron. The test for this was to run the microwave for at least a minute on the lowest power setting and see if the noise cycled on and of... read more