Models > KCDS250S1

KCDS250S1 KitchenAid Food Waste Disposer - Overview

Get Parts and Repair Help for KCDS250S1

If you know the food waste disposer repair part you need, you can browse the list of all parts on the KCDS250S1, or you can search by name or part description. You can also find your part by where it is located on the KCDS250S1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your food waste disposer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KCDS250S1 [Viewing 2 of 2]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.14

Splash Guard

This is a flexible rubber cover that fits over the top of the sink drain. It opens up in the middle and will allow you to feed water or food items into a garbage disposal while kee...

Order within the next 8 hrs and your part ships today!
$4.04

Sink Flange Gasket/Seal

Order within the next 8 hrs and your part ships today!
$4.54

Gasket

Also known as a tailpipe gasket.

Order within the next 8 hrs and your part ships today!
$36.26

Stopper

Order within the next 8 hrs and your part ships today!
$5.74

SCREW

Sold individually.

Order within the next 8 hrs and your part ships today!
$28.77

Mounting Ring

Order within the next 8 hrs and your part ships today!
$28.48

TAILPIPE

Order within the next 8 hrs and your part ships today!
$89.75

Shredding Plate

Order within the next 8 hrs and your part ships today!
$15.37

WRENCH

$4.54

FLANGE

Order within the next 8 hrs and your part ships today!

Common Symptoms of the KCDS250S1 [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

stopper leaks

  • Customer: Rex from Waukesha WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 4 of 8 people found this instruction helpful
roll 0n new gasket read more

Leak around discharge pipe

  • Customer: Richard from Freeport ME
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 2 of 6 people found this instruction helpful
Was amazed the gasket was delivered the day after I ordered it! Removed old gasket and cleaned out what I thought was accumulated waste. Replaced gasket and ran water, had a flood. What I had removed was rusted part of appliance. Unable to repair and ended up replacing the garbage disposal. Bad Luck. read more

worn out gasket

  • Customer: George E. from Marysville WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
installed new gasket by hand. read more