Models > KBRS22KGBL1 Whirlpool

KBRS22KGBL1 KitchenAid Refrigerator - Overview

Get Parts and Repair Help for KBRS22KGBL1

If you know the refrigerator repair part you need, you can browse the list of all parts on the KBRS22KGBL1, or you can search by name or part description. You can also find your part by where it is located on the KBRS22KGBL1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for KBRS22KGBL1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.21

Door Shelf End Cap Set

This door shelf end cap set contains two white end caps. Each end cap can be used as either the right or the left side. These end caps also come with adhesive strips and an instruc...

$16.84

Defrost Timer Kit - 120V 60Hz

The timer will shut off the cooling system of the refrigerator and the defrost heater will turn on.

$20.84

Bimetal Defrost Thermostat - 6" Leads

This refrigerator defrost thermostat will cut out at 55 degrees Fahrenheit and kick back in when the temperature drops to 20 degrees Fahrenheit. This thermostat controls the defros...

$5.54

Touch-Up Paint - White

$36.13

Water Inlet Valve - 120V 60Hz

$80.91

Freezer Door Gasket

This freezer door gasket is white, made of rubber and is used to seal the freezer door when closed.

$16.41

Light Switch - 2 Terminal

$3.83

SCREW

$48.50

Ice Bucket

Holds the ice when it's released by the icemaker.

$99.59

Fresh Food Door Gasket

This white gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

freezer door gasket needed replacing

  • Customer: Jeffrey from Palo Alto CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 79 of 93 people found this instruction helpful
Unplug refrigerator. Open freezer door. Lift the old gasket from the edge closest to the center of the door to expose the hex-head screws. Get a nut driver the appropriate size (1/4" if I remember) and loosen, but do not remove all of the screws. Once loosened, the old gasket can be removed. Slip the new gasket in just like the old one was. Lift the ed... read more

Fridge and freezer didn't cool enough

  • Customer: Peter from Eden UT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 59 of 66 people found this instruction helpful
I diagnosed the problem via the internet. Diagrams helped a lot. Coils were frozen over. Thawed them out overnight. Manually advanced timer and the defrost heater was operable. The defrost timer wasn't "turning" on it's own. I turned the fridge back on while I awaited the part. It worked fine for the time I had to wait. (over two weeks since I had de... read more

Frig was hot freezer was cold. Freezer was fronzen over.

  • Customer: James from Canyon Country CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 55 of 56 people found this instruction helpful
The frig was hot but the freezer was cold. I opened the back of the freezer and found the condenser all frozen over. Upon inspecting the defrost thermostat I found that it was split open, as if water got into it and the froze breaking it open. I used a blow dryer to defrost the condenser. I then spent a long time trying to find the model on-line, even the ma... read more