Models > KBMS1454SBL1

KBMS1454SBL1 KitchenAid Microwave - Overview

Get Parts and Repair Help for KBMS1454SBL1

If you know the microwave repair part you need, you can browse the list of all parts on the KBMS1454SBL1, or you can search by name or part description. You can also find your part by where it is located on the KBMS1454SBL1 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$57.83

Glass Cooking Tray

$18.69

Baseless Lamp

This is a small light bulb.

$135.59

Microwave Magnetron

This part is used to generate microwave energy/heat.

$24.31

Inlet Cover

$27.97

SUPPORT

$23.82

SWITCH

$17.77

Glass Turntable Drive Coupler

This part accepts a D-shaped shaft.

$105.23

LED Display Board

$43.91

High Voltage Capacitor

$57.62

Turntable Motor

This motor rotates the glass turntable in the microwave.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven buzzed and no heat

  • Customer: Joseph from Saint Charles IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 30 of 34 people found this instruction helpful
First took down the hood/microwave and removed the sheet metal housing.
I changed HV diode as it was the least expensive component and the first one that internet suggested and tested bad with a ohm meter. Didn't fix a thing.
Capacitor failed test with meter so I ordered and then replaced this.
Still no change so I ordered a new magnetron. ... read more

Microwave glass turntable when pop

  • Customer: Liza from Monterey CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 17 of 21 people found this instruction helpful
After popping the last few kernals of popcorn, we hear a different kind of pop sound come from our microwave oven. When we looking inside, we found that the glass turntable had broken unevenly in half. Although we didn't understand why it had happned, we did know we'd be without the use of the microwave without a new one. After less than 10 minutes surfin... read more

This is a halogen light bulb. The bulb would not burn.

  • Customer: Robert J from Laguna Vista TX
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 11 of 15 people found this instruction helpful
This is the second time this has occurred. The first was still in original warrenty. It took two Sears servicemen to dis mantel and obtain access to the bulb. One had to hold it up in the cabinet while the other took off the tope to get to the bulb. I purchased an additional extended warranty for three more years but when I called this time they said that li... read more