Models > KBLA22KRSS00

KBLA22KRSS00 KitchenAid Refrigerator - Overview

Get Parts and Repair Help for KBLA22KRSS00

If you know the refrigerator repair part you need, you can browse the list of all parts on the KBLA22KRSS00, or you can search by name or part description. You can also find your part by where it is located on the KBLA22KRSS00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for KBLA22KRSS00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$13.64

Center Crisper Rail

Actual measurements are: Length 13" Width 2" Height 1.5"

$3.96

Ladder Hook

Sold Individually.

$63.61

START-DEV

$4.46

Toe Grille Clip

$18.45

Light Switch

$2.70

Screw

This screw is sold individually.

$32.62

Defrost Thermostat

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

$3.86

Touch-Up Paint - White

$3.96

Humidity Control Slide

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The refrigerator was not getting cold and the coils were not defrosting.

  • Customer: Cheryl K from Pinellas Park FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 53 of 59 people found this instruction helpful
Start by removing the freezer door and inner baskets so you have some space. Next, take out the ice maker by removing the 3 screws that attach it to the side and unplug it from the harness. Then the cover for the thermistor and the fan vent should be popped off carefully leaving the back cover only. The back cover is held on by 4 screws, one in each corne... read more

Cracked & Snapped Center Crisper Rail

  • Customer: Ruth from Roxbury MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 40 of 41 people found this instruction helpful
A very easy fix took all of five minutes read more

Freezer cold, refrigerator warm

  • Customer: Gordon from Ben Wheeler TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 60 of 101 people found this instruction helpful
Overload relay accessible from back, by compressor unit. Very easy to change out. Diagram from your site placed defrost thermostat in same area.It wasn't. Found another diagram, showed it in refrigerator light area, took that apart, not there. Yet another diagram showed it in the duct work area at back of refrigerator cabinet. Not there. Finally removed b... read more