Models > KBDS250V1

KBDS250V1 KitchenAid Food Waste Disposer - Overview

Get Parts and Repair Help for KBDS250V1

If you know the food waste disposer repair part you need, you can browse the list of all parts on the KBDS250V1, or you can search by name or part description. You can also find your part by where it is located on the KBDS250V1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your food waste disposer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the KBDS250V1 [Viewing 2 of 2]

$3.96

Sink Flange Gasket/Seal

$70.66

Disposal Stopper/Starter

This is a garbage disposal start and stopper assembly. Also known as an Actuator.

$4.46

Gasket

$68.66

Start Switch Kit

$27.92

TAILPIPE

$17.55

GASKET

$11.79

WRENCH

$4.46

FLANGE

$40.07

FLANGE

$9.76

BOLT

Common Symptoms of the KBDS250V1 [Viewing 1 of 13]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Leak around discharge pipe

  • Customer: Richard from Freeport ME
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 2 of 5 people found this instruction helpful
Was amazed the gasket was delivered the day after I ordered it! Removed old gasket and cleaned out what I thought was accumulated waste. Replaced gasket and ran water, had a flood. What I had removed was rusted part of appliance. Unable to repair and ended up replacing the garbage disposal. Bad Luck. read more

worn out gasket

  • Customer: George E. from Marysville WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
installed new gasket by hand. read more

Switch was clogged with food

  • Customer: Alvaro from Norwalk CT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
I need to put rubber washer and internal nut to retain the switch in place and the cover switch doesn't retain the screw ( this was passing through without retain the cover ) read more