This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air ...
This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb i...
This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part ...
This turntable tray is for microwaves.
Turntable tray rotates in the center of the microwave to help ensure the food cooks evenly.
Follow the instructions in the owner's manual when installing this part.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Josie
December 16, 2021
Replaced the main fuse and it works for a bit and then blows the fuse
For model number JVM3160EF1ES
Hello Josie, Thank you for the question. This could be caused by a faulty Door Switch. We suggest testing the three switches with a Multimeter to check the continuity. You can check to see if they are reading Normally Open or Normally Closed. It will say on the switch its self what it needs to read. We hope this helps!
Tripping circuit breaker when turned on. What is the most likley cause?
For model number JVM3160EF1ES
Hello Doug, thank you for your question. The most likely cause is too much load on the circuit in the breaker box. We hope this helps.
Was this helpful?
Thank you for voting!
Lenny
November 2, 2021
Why does the microwave make noises after it done cooking if i shut the door the noises stopps when i shut the door it starts up again i have replaced all the door switches but throws the breaker
For model number JVM3160EF1ES
Hello Lenny, thank you for your question. There is a few things that can cause your microwave to make a sound. If you hear a humming noise when the microwave receives no power, the transformer may be emitting the sound. Part number PS8754405. If the magnetron is defective, it may cause a loud humming or buzzing noise. Part number PS11773832. The High Voltage Diode will also make a humming noise. Part number PS12342226. We hope this helps.
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D
1. Unplug unit 2. Open door, remove two screws above the top trim piece, slide and remove trim. 3. Remove screw behind control board and top left corner, then release from position. 3b. Unplug all wire terminations and set control panel aside. 4. Remove two screws securing latch board, lift and rotate board
... Read moreout of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.