Models
>
JVM1540DM2WW
JVM1540DM2WW General Electric Microwave - Overview
Sections of the JVM1540DM2WW
[Viewing 7 of 7]
Manuals & Care Guides for JVM1540DM2WW
Click to downloadInstall
Installation Instructions
(5.63MB)
Manual
Owner's Manuals
(2.56MB)
Manual
Owner's Manuals
(2.05MB)
Keep searches simple, eg. "belt" or "pump".
FUSE
PartSelect #: PS1481237
Manufacturer #: WB27X10928
This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the micro...
$10.58
In Stock
Glass Cooking Tray
PartSelect #: PS956214
Manufacturer #: WB49X10129
There are two different couplers (also known as a turntable shaft) that can be used for this tray - a male D-shaped shaft and a female D-shaped shaft. The couplers are sold separately.
$106.23
In Stock
Grease Filter
PartSelect #: PS228066
Manufacturer #: WB06X10359
Sold individually. Most microwaves require 2.
$54.19
In Stock
Primary Door Interlock Switch
PartSelect #: PS237015
Manufacturer #: WB24X10047
This interlock switch is located in the door latch.
$33.44
In Stock
Stirrer Fan Cover
PartSelect #: PS1480811
Manufacturer #: WB06X10712
The stirrer fan cover in your microwave can be found on the roof of the microwave. It protects the fan from damage and debris. This fan cover is made of white plastic and is approximately 7.5 inches i...
$21.44
In Stock
Light Bulb
PartSelect #: PS1481517
Manufacturer #: WB36X10328
Sold individually. Appliance may take 2.
$26.65
In Stock
Rotating Ring
PartSelect #: PS1480805
Manufacturer #: WB06X10705
The rotating ring in your microwave rests under the microwave plate, and allows it to rotate when the microwave is running. It is a round plastic ring with 3 wheels spaced out around the perimeter. If...
$40.16
In Stock
EXHAUST ADAPTER
PartSelect #: PS12709817
Manufacturer #: WB02X32715
This is the replacement damper bracket for your microwave. It is made of plastic and is approximately 11 inches wide and 3 inches long. The damper bracket attaches to the outer cabinet and directs air...
$8.54
In Stock
DIODE-CABLE ASM
PartSelect #: PS16219547
Manufacturer #: WB27X35382
This part is the replacement high-voltage diode for your microwave. It is approximately 3 inches long and is sold individually. The high voltage diode is an electrical current control device inside yo...
$8.54
In Stock
Door Latch
PartSelect #: PS952070
Manufacturer #: WB02X11096
Used to keep the microwave door closed during operation.
$10.42
In Stock
Plastic Rivet
PartSelect #: PS222397
Manufacturer #: WB01X10055
This part is the replacement plastic rivet, or stirrer fan cover clip for your microwave. It is made of white plastic and is approximately ¼ inch in diameter, and ½ inch long. The plastic rivet holds ...
$9.49
In Stock
Turntable Shaft
PartSelect #: PS1480804
Manufacturer #: WB06X10704
Also known as Coupler.
$24.73
In Stock
Questions And Answers for JVM1540DM2WW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
- < Prev
- 1
- Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Melissa
January 16, 2023
In need of the wall mounting bracket. Bought microwave from someone and bracket from our old one will not work. It's an L shape.
For model number JVM1540DM2WW
Hello Melissa, thank you for writing. The mounting plate for your model JVM1540DM2WW is part PS16216996. Good Luck and have a great day.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
MOUNTING PLATE ASM
$13.76
In Stock
David
March 1, 2023
Our microwave turns on for a second and then makes awful noise. Any idea what could be causing this?
For model number JVM1540DM2WW
Hello David, thank you for reaching out. According to our research, the issue is probably with the magnetron, part number PS1481236. Before replacing the magnetron, we suggest checking the turntable drive motor, part number PS953609. We hope this information helps!
Was this helpful?
Thank you for voting!
Related Parts:
Magnetron
$195.67
In Stock
Turntable Drive Motor - 120V 60Hz
$36.68
In Stock
Stanton
December 24, 2023
My unit have no power .two plugs on lower right side above the filter one is burnt 110 115 on the diaogram
For model number JVM1540DM2WW
Hi Stanton, thank you for your inquiry. The parts you are referring to are the thermal cut-off devices. Thermal cut-off is a safety device that shuts off the microwave if it overheats. We would recommend replacing the burnt thermal cut-off. The thermostats on the lower right side for your model are part number PS1481241, and PS2321365. Good luck with the repair!
Was this helpful?
Thank you for voting!
Related Parts:
THERMOSTAT
$29.17
In Stock
THERMOSTAT VENT
$9.82
In Stock
- < Prev
- 1
- Next >
Common Symptoms of the JVM1540DM2WW
[Viewing 6 of 6]No heat
Fixed by
these parts
these parts
Show All
Won’t turn on
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Door not closing properly
Fixed by
these parts
these parts
Show All
Tray won’t turn
Fixed by
these parts
these parts
Show All
Doesn’t shut off
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Microwave completely stopped working
Turned out the issue was easily solved by replacing a single, inexpensive fuse.
First off, UNPLUG THE MICROWAVE.
The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the mic ... Read more rowave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
First off, UNPLUG THE MICROWAVE.
The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the mic ... Read more rowave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
Read less
Parts Used:
-
Kim from Cliffside Park, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
953 of 1228 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I diagnosed the problem incorrectly: based on a previous repair.
-
Ralph from Brandon, FL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
64 of 136 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Microwave runs with the door open
Remove microwave outer cover. Turn on side & locate the upper & lower door switches. Better to replace in pairs even if one is ok. Remove the wire harness to each switch. Then replace switch and re connect the wire harness. Re attach outer cover
and test to see if that solved the problem. If so then well done!!
and test to see if that solved the problem. If so then well done!!
Parts Used:
-
Thomas from Andover, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
35 of 50 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!