JVB37H1BB General Electric Range Hood - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Downdraft wouldn't work at all..... broken sensor
I pulled up the wires that the membrane switch hooks to and connected the new one with the new sensor pushed them down the opening. Took the sticky paper off the up and down button and stuck it too the indentation where it goes and there you have it as good as new! Works great!
Parts Used:
-
Richard from Chardon, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
19 of 32 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Raise and lower switch stopped working on downdraft power vent
In the process of diagnosing the problem, the circuit board burned out and the fan switch broke. Had a great deal of difficulty removing the unit. Had to disconnect gas line to range top and remove it first before I could remove the downdraft unit. I still had to get some crazy glue to hold down new microswitch on top of the unit. It is finally working fine now.
Parts Used:
-
Louis from Lorton, VA
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
20 of 40 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
putting membrane switch in
Received membrane switch quick after I ordered it. Connected switch to downdrafts system in less than 15 minutes. Tested system to make sure it worked. very happy with partsselect shipped quickly after ordering.
Parts Used:
-
jeffrey from hickory, NC
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!