This part is the replacement membrane switch for your range hood. It is approximately 4 inches in length, and the part of the switch that you push is black in color. The membrane switch or downdraft v...
This is a single roller and it is a part for multiple appliances in your household. You may also know this as a bearing roller or a wheel assembly. It is roughly one inch by one inch in size, and is s...
I pulled up the wires that the membrane switch hooks to and connected the new one with the new sensor pushed them down the opening. Took the sticky paper off the up and down button and stuck it too the indentation where it goes and there you have it as good as new! Works great!
Disconnected power and removed electrical cover Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires. Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for
... Read more replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft. Installed new controller. Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Received membrane switch quick after I ordered it. Connected switch to downdrafts system in less than 15 minutes. Tested system to make sure it worked. very happy with partsselect shipped quickly after ordering.