Models > JTP35WM1WW

JTP35WM1WW General Electric Oven - Overview

Get Parts and Repair Help for JTP35WM1WW

If you know the oven repair part you need, you can browse the list of all parts on the JTP35WM1WW, or you can search by name or part description. You can also find your part by where it is located on the JTP35WM1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for JTP35WM1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$1.70

Screw

This screw is sold individually.

$13.89

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$4.01

Oven Bulb Lens Cover - Glass

$17.67

Oven Light Housing

Must buy bulb locally as per manufacturer.

$26.89

Door Gasket

This oven door gasket prevents heat from escaping the oven cavity when in use.

$2.36

Single Screw Only

Sold Individually.

$37.80

WINDOW PACK ASM

$2.79

Screw

Sold Individually.

$12.38

SCREW-PKG 12

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 20 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

F2 error code

  • Customer: George from Fiskdale MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 8 of 10 people found this instruction helpful
After reviewing the potential causes for the error code, I decided I'd try to change out the temp sensor. Using the ohmeter, I saw the difference immediately between the old and new sensor. The sensor is accessed from the back of the stove, and must be slide out to gain access to the rear panel. Since the stove I have is a built in, removing the stove and... read more

front oof oven cover was peeling off.

  • Customer: David from Tuscola TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 9 of 16 people found this instruction helpful
replacing front was very easy and took about 15 minutes, save about $100.00, so didn't mine a bit. read more