Models > JSD2789HES

JSD2789HES Jenn-Air Refrigerator - Overview

Get Parts and Repair Help for JSD2789HES

If you know the refrigerator repair part you need, you can browse the list of all parts on the JSD2789HES, or you can search by name or part description. You can also find your part by where it is located on the JSD2789HES by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for JSD2789HES parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$126.87

Ice Maker

This replacement ice maker mechanism does NOT come with a cover, a wire harness, or the mounting hardware. Must be ordered separately.

$2.70

Screw

This screw is sold individually.

$37.21

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$3.96

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators.

$56.00

Water Filter

This Puri-Clean water filter will fit most Maytag and Jenn Air refrigerators that have a screw-in filter.

$3.86

Light Bulb - 40W 120V

Sold individually.

$81.84

Adaptive Defrost Board

This part allows the refrigerator to go into defrost mode only when required.

$2.70

Screw

This screw is sold individually.

$3.32

Light Bulb - 7W

Sold individually. This bulb is a 7 watt appliance incandescent light bulb.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water overflowed ice maker turnning ice bucket into solid mass of ice

  • Customer: Harry from Grand Ledge MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 185 of 255 people found this instruction helpful
My ice maker has been shedding its non-stick coating for over a year. Within the last month of so, it started pouring water into the ice bucket below, turning it into a solid mass of ice. So I purchased a new ice maker assembly. I encountered two problems not mentioned in the 21 or so do-it-yourselfer repair stories that precede this one. First problem: o... read more

Fridge Side Warm Freezer Fine

  • Customer: james from livermore CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 106 of 112 people found this instruction helpful
Removed the Hex head small screw at the middle back of the Back wall of the fridge above the top shelf. Removed the 2 small Hex Head screws that go into the of the Plastic cover upwards into the top roof of the fridge.
I ended up with an extra screw so I dont know what I did...
The hard part is pushing up on the two tabs, one on each side in the ex... read more

not making ice

  • Customer: Pat from Dallas TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 45 of 51 people found this instruction helpful
Installed new ice maker. It was easy - loosen two screws and unplug old wire harness. Put new unit in place. Did not realize new unit would not come with wire harness, but transferred old one to new ice maker (easy) and, "voila" some ice in 24 hours -- much ice since then. I am a 68 year old woman and it was "sort of fun" doing this job. read more