Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JRSD224N (7N07A)

JRSD224N (7N07A) Jenn-Air Refrigerator - Overview

Get Parts and Repair Help for JRSD224N

If you know the refrigerator repair part you need, you can browse the list of all parts on the JRSD224N, or you can search by name or part description. You can also find your part by where it is located on the JRSD224N by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for JRSD224N parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.05

Screw

Sold individually.

$5.15

Screw

This screw is sold individually.

$6.59

BULB-LIGHT

Sold individually. This bulb is a 7 watt appliance incandescent light bulb.This appliance light bulb is two inches long. It is used for many clothes dryers.

$2.80

Screw

Sold individually.

$4.27

Inlet Hose Washer

This high pressure inlet hose washer is black. It is an inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers.

$19.66

Ice Bin Drive Ring

This drive ring is three inches in diameter. It is all white in color and is made of plastic. This ring is used with a refrigeraor's icemaker assembly.

$2.80

Screw

This is screw is sold individually.

$5.13

Compression Nut

This compression nut is used with the plastic water line of the icemaker assembly.

$5.00

Plastic Tubing

1/4" Plastic tubing, 8 1/2 feet long.

$108.57

Ice Bucket Auger Drive Motor Kit

This motor kit comes with a thermally protected motor, a washer and a mounting bracket. The motor performs eighteen revolutions per minute, carries 115 volts, and drives the auger for the icemaker.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

the ice/water actuator switch burnt out and was stuck on.

  • Customer: Jon from Nampa, ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 13 people found this instruction helpful
Removed the rubber cover over the actuator switch. Used a screwdriver to remove the switch, disconnected the wires. I then removed the switch from the mounting bracket using a small philips head screw driver. Installed the new switch on the mounting bracket then installed the switch onto the freezer door. The only difficult part was installing the rubbe... read more

Ice bucket auger yoke was stripped out and turned freely

  • Customer: James from Pineville, LA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 7 of 7 people found this instruction helpful
Removed the ice bucket from the freezer. Removed the single screw on the left side with a nut driver, then lift and pull the tray toward you...there is a wiring harness in back of the tray that I had to unplug...easy, pinch the sides of the plastic connector and it disconnects..and the tray came out of the refrigerator...and the cussing started. Since the th... read more

The old ice maker was leaking water when it filled freezing the ice in the accumulation tray into one big lump.

  • Customer: Robert from Franklin, TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 6 of 7 people found this instruction helpful
First, I read the instructions that came with the replacement ice maker, which I found confusing because they were apparently written to be installed in some other make of refrigerator. However, after removing the white plastic cover on the new unit and insuring that it was identical to the one that came with the refrigerator, I removed the old unit by first... read more