Models > JP340BM1BB

JP340BM1BB General Electric Cooktop - Overview

Get Parts and Repair Help for JP340BM1BB

If you know the cooktop repair part you need, you can browse the list of all parts on the JP340BM1BB, or you can search by name or part description. You can also find your part by where it is located on the JP340BM1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JP340BM1BB [Viewing 1 of 1]

$83.91

Large Haliant Burner with Limiter - 8"

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$16.02

Foam Rubber Tape

$3.62

Secure Down Bracket

$77.96

Surface Element Switch - 1900W

$6.62

KNOB ASM (INFINITE)

$16.66

Switch Seal

This part goes between the infinite switch (under the cooktop) and the knob.

$3.00

WASHER

$27.62

Tape

This roll contains 108 inches of tape.

Common Symptoms of the JP340BM1BB [Viewing 1 of 128]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Large burner would not get hot

  • Customer: Kevin from Leominster MA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 24 of 33 people found this instruction helpful
Repair was very simple. Removed 2 screws under the cooktop, tilt the cooktop back, unplug 4 wires from 8" burner, remove two screws holding retaining clips, install new burner in reverse order. Very simple! read more

Left rear element would not get hot.

  • Customer: John from Hopewell Junction NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 12 of 17 people found this instruction helpful
FIRST TURN OFF THE CIRCUIT BREAKERS THAT POWER THE COOKTOP!! Remove the cooktop from the counter by removing the screws from the mounting straps under the counter. Then remove the screws that hold the glass cooktop to the frame and lift off the glass top. Next lift up the bad element and unplug one wire from the bad element and plug it into the new element. ... read more

Intermitently the switch would stick on high.

  • Customer: Larry from Mattawa WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 4 of 7 people found this instruction helpful
Pulled unit from the counter top, removed all side screws holding the top on and set the top off. Removed switch mount section, Identified the terminal wire locations. I then removed the old switch and connected the wires per my diagram. Returned all screws, tested the burner for opeation and reset the cooktop back into the counter hole and secured. read more