Models > JMV8208AAW

JMV8208AAW Jenn-Air Microwave - Overview

Get Parts and Repair Help for JMV8208AAW

If you know the microwave repair part you need, you can browse the list of all parts on the JMV8208AAW, or you can search by name or part description. You can also find your part by where it is located on the JMV8208AAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for JMV8208AAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

SCREW

$13.02

Air Filter

Sold individually.

$17.79

Halogen Lamp

$11.80

Black Sleeve Diode

$44.27

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$15.25

Charcoal Filter

$67.96

Rectangular Cooking Tray

$2.70

Wave Guide Rivet

This rivet is used for the stirrer cover/wave guide. They are sold individually.

$2.70

Cabinet Screw

This screw is sold individually.

$4.60

WASHER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sparks and loud hum from oven

  • Customer: Guy from Bellingham MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 40 of 64 people found this instruction helpful
1. I went to the internet to find the service manual for the Maytag microwave.
2. I opened up the oven and started measuring the resistance of the diode, capacitor, transformer, and magnetron between terminals and then to ground. The transformer and magnetron were well within the resistance limits. The diode was shorted in both directions(+-). The capac... read more

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 27 of 33 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

The lamp burns out occasionally

  • Customer: Gertrude from Milford DE
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 17 people found this instruction helpful
Once I got the replacement bulb, the repair was
easy. I needed to unscrew one side of the lamp assembly and pop the new bul in.

My problem was getting the right light. The local hardware store didn't carry quite the right halogen lamp and the one I bought burned out the wires that hold the light. THis was a costly repair --- about $100. S... read more