Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JMC5200AAW

JMC5200AAW Jenn-Air Microwave - Overview

Get Parts and Repair Help for JMC5200AAW

If you know the microwave repair part you need, you can browse the list of all parts on the JMC5200AAW, or you can search by name or part description. You can also find your part by where it is located on the JMC5200AAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.22

Turntable Roller Guide

This roller is located underneath the glass turntable. With the help of the motor, this roller helps to rotate the glass tray. This part takes the place of the coupling.

$52.44

Door Interlock Switch Kit

This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15 Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged.

$59.66

Cooking Tray

This tray rotates in your microwave ensuring more even temperatures.

$46.87

Turntable Motor

This motor rotates the glass turntable in the microwave.

$4.62

Wave Guide Rivet

This rivet is used for the stirrer cover/wave guide. They are sold individually.

$20.94

Wave Guide Cover

This part guides the waves to the inside of the microwave to cook your food.

$4.79

Door Latch

Also known as a door hook.

$64.85

CAPACITOR-

The high-voltage capacitor is an electronic device that holds a charge of electricity in the high-voltage circuit of the microwave. The capacitor stores electricity similar to how a battery does, but can be charged and discharged instantly. If your microwave will not produce heat, there could be an issue with the capacitor. This genuine OEM replacement high-voltage capacitor is approximately 5 inches long x 2 inches wide, and is compatible with most microwave brands. NOTE: Make sure your microwave is unplugged, and that your capacitor is discharged before you begin this repair. A capacitor stores large amounts of electricity even after your microwave is unplugged.

$17.76

Door Latch Spring

$5.36

Fuse - 15 Amp 250V

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island, WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 62 of 73 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

Broken tray ring for rotation of dish.

  • Customer: Michael from Sewanee, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 16 of 17 people found this instruction helpful
Used needle nose to pull off piece of old ring. Layed in new one. read more

Close the door on the microwave, punch in the # nothing happened

  • Customer: Robert S. from Stafford, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 14 of 20 people found this instruction helpful
I removed the unit from the wall. Took the cover off. Set the unit on its side. It revealed the working parts. Removed the old micro switches. Put in the new oness. Presto, it worked. Very easy for me.
The parts was delivered almost before my notice they were shipped. read more