Models > JKP75BM1BB

JKP75BM1BB General Electric Oven - Overview

Get Parts and Repair Help for JKP75BM1BB

If you know the oven repair part you need, you can browse the list of all parts on the JKP75BM1BB, or you can search by name or part description. You can also find your part by where it is located on the JKP75BM1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$1.70

Screw

This screw is sold individually.

$8.32

Halogen Light Bulb - 50W

This light bulb is used in the interior oven.

$2.36

Single Screw Only

Sold Individually.

$2.62

Screw

This screw is black in color and sold individually.

$2.79

Screw

Sold Individually.

$12.38

SCREW-PKG 12

$5.99

LENS OVEN LAMP

$1.78

SCREW 10-16 X 1.000 HWH

$39.92

RACK OVEN

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 35 of 48 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 15 of 18 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more

I kept getting An F2 error and the temperature did not seem accurate

  • Customer: Chad from Bloomington IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 7 of 8 people found this instruction helpful
1) pull out the stove
2) remove the 7 sheet metal screws holding the back panel on. (the panel that also covers where the cord splits and connects to the oven.
3) Find the small plastic connector located in the middle of the back of the range and unplug it.
4) open the front of the oven and remove the one screw holding in the oven temp sensor... read more