Models > JJW9527DDW

JJW9527DDW Jenn-Air Oven - Overview

Get Parts and Repair Help for JJW9527DDW

If you know the oven repair part you need, you can browse the list of all parts on the JJW9527DDW, or you can search by name or part description. You can also find your part by where it is located on the JJW9527DDW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$17.20

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

$24.04

Hinge Bracket - Left or Right Side

$38.48

Oven Rack

Sold individually.

$10.79

Halogen Light Bulb

This small halogen light bulb is located inside the oven cavity.

$2.70

SCREW

$3.82

NUT

$31.99

Broil Pan Insert

$2.70

Screw

This screw is sold individually.

$49.09

Broil Element

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burned terminal block and filter board

  • Customer: Joseph from Decatur GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 31 of 68 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more

Oven door would not close tightly.

  • Customer: Daniel from Rochester Hills MI
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 6 of 10 people found this instruction helpful
DOOR HINGE: Lifted the door out of place and layed it on the floor. Removed the six screws (three on top and three on bottom) from the door to remove the front panel exposing the hinges. Removed three screws from each hinge to remove them. Reversed the process to complete. HINGE BRACKET: Would recommend replacing these with hinges. After removing the screws ... read more

oven temp wrong

  • Customer: Alan from Wallkill NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 4 of 5 people found this instruction helpful
Remove the oven door. Remove 3 self tappers on rear wall of oven to take off a round access panel. Pull out a pre-cut rectangle of insulation. Next I removed the 2 screws holding the sensor in place. Pulling the sensor out a bit told me I was "touching" the correct wires in the SMALL rectangular opening. The wires are not visable and 2 hands do not fit in t... read more