Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JJW8527CAB

JJW8527CAB Jenn-Air Wall Oven - Overview

Get Parts and Repair Help for JJW8527CAB

If you know the wall oven repair part you need, you can browse the list of all parts on the JJW8527CAB, or you can search by name or part description. You can also find your part by where it is located on the JJW8527CAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for JJW8527CAB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

Order within the next 1 hr and 7 mins and your part ships today!
$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

Order within the next 1 hr and 7 mins and your part ships today!
$39.96

Oven Rack

Sold individually.

Order within the next 1 hr and 7 mins and your part ships today!
$4.79

SPACER- DE

Order within the next 1 hr and 7 mins and your part ships today!

Door Lock Switch

This door lock switch is two inches long. It is a black and metallic switch that carries 120 volts.

INSULATION

$4.94

Washer

Order within the next 1 hr and 7 mins and your part ships today!

USE WPL 3605F236-50

EXTENSION-

MANUAL, USE & CARE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 107 of 123 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

No clock display

  • Customer: Cheryl from Mesa, AZ
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 48 of 49 people found this instruction helpful
1. Turned off the circuit breaker for the oven.
2. Opened oven door used a phillips screwdriver to remove four black screws from under the top panel.
3. Lifted panel slightly & removed from oven.
Removed four screws using 1/4" nut driver to remove old display unit. Disconnected three wire harnesses.
4. Connected three wire harnesses to n... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 46 of 57 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more