Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JGS9900BDF

JGS9900BDF Jenn-Air Cooktop - Overview

Get Parts and Repair Help for JGS9900BDF

If you know the cooktop repair part you need, you can browse the list of all parts on the JGS9900BDF, or you can search by name or part description. You can also find your part by where it is located on the JGS9900BDF by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for JGS9900BDF parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$17.73

Burner Electrode

This part has a male spade and helps your burner ignite and produce flame. If a wire lead is needed, you can purchase locally.

$5.00

Screw

Sold individually.

$56.42

Bake Igniter

This part ignites to help bake your food.

$5.15

Screw, 10-16 x 1

This screw is sold individually.

$40.90

Burner Head with Electrode

$7.33

Grate Foot

Sold individually. Must be held in with adhesive. Part # PS972585.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$45.80

Door Gasket

This oven door gasket comes with built in retaining clips.

$5.15

Screw, Igniter

This screw is sold individually.

$36.36

Burner Head

This part includes the spark igniter.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion, MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 58 of 58 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more

Ignitor was bad on upper oven

  • Customer: David from Temple Terrace, FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 45 of 50 people found this instruction helpful
First I removed the lower tray and all parts covering the ignitor on the upper oven. 2. Then I removed the screws holding down the ignitor and flame distributor. 3. I then had to pull out the oven from the wall and remove the back panel to expose the wires connecting the ignitor. This required the removal of about six screws but they were fairly easy to ... read more

Needed to replace oven door gasket.

  • Customer: Lori from Scottsdale, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 44 of 54 people found this instruction helpful
First removed the old gasket using a needle-nose pliers. Then placed new gasket by inserting the little clips on the gasket. Took 5 minutes. Great instructions from Repair Forum. read more