Models > JGS8850BDQ

JGS8850BDQ Jenn-Air Range - Overview

Get Parts and Repair Help for JGS8850BDQ

If you know the range repair part you need, you can browse the list of all parts on the JGS8850BDQ, or you can search by name or part description. You can also find your part by where it is located on the JGS8850BDQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JGS8850BDQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$15.84

Burner Electrode

This part has a male spade and helps your burner ignite and produce flame. If a wire lead is needed, you can purchase locally.

$55.77

Gas Oven Igniter - Vertical Mount

This gas oven igniter is a little over three inches long. It has a white ceramic base and a gray silicon carbide igniter. This igniter assembly comes with its own metallic mounting bracket, and an eight inch long wire lead with a plastic plug.

$3.76

Grate Foot

Sold individually.

$2.70

Screw

Sold individually.

$24.90

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Igniter Screw

This screw is sold individually.

$32.57

Door Gasket

This oven door gasket comes with built in retaining clips.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick ME
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 114 of 126 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 63 of 71 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 39 of 39 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more