Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JGS8850ADQ

JGS8850ADQ Jenn-Air Range - Overview

Get Parts and Repair Help for JGS8850ADQ

If you know the range repair part you need, you can browse the list of all parts on the JGS8850ADQ, or you can search by name or part description. You can also find your part by where it is located on the JGS8850ADQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JGS8850ADQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$50.37

Oven Igniter - Vertical Mount

This broil igniter assembly comes with its own metallic mounting bracket and an seven inch long dual wire lead with a plastic plug.

$23.99

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$66.33

Inner Door Glass Pane

Glass only.

$4.63

Storage Drawer Wheel and Shaft

This wheel and shaft is used to open and close the bottom storage drawer of a range/stove.

$31.67

Door Hinge - Left or Right Side

Sold individually.

$5.15

Insulation

This strip of insulation is located within the oven door.

$51.19

Bake Burner

$4.89

SCREW

Part might differ in appearance, but functions same as original. Sold individually.

$34.62

KIT-VALVE

$96.10

BAFFL-BRNR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick, ME
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 192 of 215 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham, AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 120 of 129 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

Our oven would not heat up, smelled like gas.

  • Customer: Theresa from Yorkville, IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 50 of 55 people found this instruction helpful
I removed the oven door, unscrewed a couple of screws, replaced the ignitor, put screws back in, done! Sometimes it would take my oven up to an hour to heat up and sometimes it just wouldn't heat up, just fill the house with a gas smell. Now, it heats up in about 3 minutes!! We were considering buying a new oven, we will just keep this one. $40.00 beats $70... read more