Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JGS8750BDS

JGS8750BDS Jenn-Air Range - Overview

Get Parts and Repair Help for JGS8750BDS

If you know the range repair part you need, you can browse the list of all parts on the JGS8750BDS, or you can search by name or part description. You can also find your part by where it is located on the JGS8750BDS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JGS8750BDS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$50.37

Oven Igniter - Vertical Mount

This broil igniter assembly comes with its own metallic mounting bracket and an seven inch long dual wire lead with a plastic plug.

$23.99

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$41.08

Burner Head with Electrode

$36.42

Burner Head

This part includes the spark igniter.

$22.22

2 Piece Broiler Pan

The top of this part is now black.

$66.33

Inner Door Glass Pane

Glass only.

$30.45

Burner Head with Electrode - Small

$5.15

Insulation

This strip of insulation is located within the oven door.

$51.19

Bake Burner

$40.73

HINGE- DOO

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick, ME
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 193 of 216 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham, AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 120 of 129 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion, MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 58 of 58 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more