Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JGR8875QDS > Parts

JGR8875QDS Jenn-Air Range - Parts

All parts for the Jenn-Air Range JGR8875QDS

Below is a list of all parts for the Jenn-Air Range JGR8875QDS. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the JGR8875QDS
1-14 of 147
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.88

Light Bulb - 40W

This an authentic OEM 40-Watt replacement light bulb, used in a number of household appliances. It is specially designed to withstand extreme temperatures, which is why these repla...

$50.37

Oven Igniter - Vertical Mount

This broil igniter assembly comes with its own metallic mounting bracket and a 7-inch-long dual wire lead with a plastic plug. This part will need to be repaired if your oven element is giving off no heat or very little, or is not heating evenly. You may also notice a smell of gas. The ignitor may still be glowing, but could still have gone bad. You will need a 1/4-inch nut-driver and a 5/16 nut-driver. Open the oven door and pull the door off the hinges to completely remove. Pull out the racks. Using your 1/4-inch nut driver, take out the screws at the bottom rear end of the oven, which will allow you to completely remove the bottom. Unscrew the nuts holding the igniter in place. Remove the igniter with the 5/16 nut driver. You should now have access to remove the old igniter.

$24.22

Short Oven Sensor Kit

The temperature sensor on your oven detects the temperature within the oven cavity. If you notice your oven is too hot, not hot enough, or does not heat evenly, the short oven sens...

$3.02

Screw

This screw is sold individually.

$4.15

Grate Foot

Sold individually. Must be held in with adhesive. Part # PS972585.

$5.52

Screw

Sold individually.

$15.59

Valve Knob

This knob accepts a D-shaped shaft. Sold individually.

$6.49

Levelling Leg

This is a levelling leg for your oven, range, or stove. It is just under 3 inches long, is all black in colour, and is made entirely out of plastic. The levelling legs on your oven allow your appliance to sit perfectly flat. The new one may be longer in length than your original, but will work the same. Install the new leveling leg, and test if you have it adjusted properly by putting the appliance on four legs. Adjust in or out as required if your oven is rocking. It is recommended to check the other three levelling legs on your appliance in case they are also damaged or worn.

$67.57

Igniter - Horizontal Mount

This can be used for either the bake igniter or broil igniter in your appliance.

$66.33

Inner Door Glass Pane

Glass only.

$8.72

ADHESIVE

$37.84

Door Hinge - Left or Right Side

This door hinge can be used for the left or right side. As per the manufacture if the hinges have never been replaced,on the appliance,they suggest to replace the door hinge receptacle kit.

$3.75

Hex Nut

This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, ref...

$3.02

Screw

This screw is sold individually.

All Parts for the JGR8875QDS
1-14 of 147