JGP640ES2BG General Electric Cooktop - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Igniter would not spark
Electricity and gas were disconnected from the range. The cook top was removed from the counter by lifting and then turned upside down to gain access to the spark module. The cover was removed by unscrewing 17 screws to access the module and wires. All the wirecolors and locations were written down on a piece of paper and removed from the module. The module was removed and replaced with the new part. All the wires were re-connected using the diagram made earlier and the range was tested for spark before the cover was replaced. After replacing the cover, the sealing gasket between the cook top and the counter was replaced and the cook top re-installed. Electricity and gas were re-connected. It works fine now.
Parts Used:
-
Thomas from North Potomac, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
6 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
igniter on gas stove failed
Took my handyman less than five minutes to install new part. Your website with the clear picture and description was such a help in ordering the correct part.Thank you!
Parts Used:
-
fay from las vegas, NV
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!