Models > JGP336BEV2BB

JGP336BEV2BB General Electric Cooktop - Overview

Get Parts and Repair Help for JGP336BEV2BB

If you know the cooktop repair part you need, you can browse the list of all parts on the JGP336BEV2BB, or you can search by name or part description. You can also find your part by where it is located on the JGP336BEV2BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JGP336BEV2BB [Viewing 2 of 2]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$1.93

Screw

This screw is sold individually.

$24.77

Surface Burner Spark Electrode

This part helps your burner ignite and produce flame.

$2.79

SCREW

Sold Individually.

$13.68

Burner Bowl Seal

$12.61

Burner Bowl - Medium

$79.45

Burner Spark Module - 120V 60Hz

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$2.79

Single Screw Only

Sold Individually. This only comes with 1 screw, not the 4 pictured above.

$64.07

Burner Grate

Sold individually.

$12.16

Burner Bowl - Large

This black drip bowl is sold individually.

$5.98

Single Liquid Propane Orifice Spud - Medium Burner

Sold Individually. Order quantity needed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Top four burners on oven would not light without using match

  • Customer: David from Logansport IN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 40 of 50 people found this instruction helpful
Really simple..Opened the top of the oven and followed the four wires hooked to the igniters on the burners to the back of the oven. Unscrewed top section in back of oven. Found spark module screwed to uppper back of oven on right side. Used a nutdriver to take a few screws out of upper back of oven. Unscrewed spark module from oven. There are six wires - fo... read more

Burner igniter needed to be replaced

  • Customer: Thomas from Bloomsbury NJ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 18 of 33 people found this instruction helpful
Assumed the entire top of the range would have to be lifted off. Removed the three screws inside the top of the over door and then noticed the two screws holding the dish around the burner. They were tight and required WD-40 and then a sharp tap and came off.
Important: Notice the direction your old igniter is plugged into the wire. It is not clea... read more

My wife wanted different color stove top grate & burner caps.

  • Customer: Michael from Bakersfield CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 9 of 10 people found this instruction helpful
Called GE for part number crossover from gray to black and asked for an email quote. Called Parts Select for pricing, which was alot lower! Shipping took five days and less then $8.00 buck....now mama's happy!!!! Thanks for great frendly service from Mike in California. read more