Models > JGC9430BDB

JGC9430BDB Jenn-Air Cooktop - Overview

Get Parts and Repair Help for JGC9430BDB

If you know the cooktop repair part you need, you can browse the list of all parts on the JGC9430BDB, or you can search by name or part description. You can also find your part by where it is located on the JGC9430BDB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$15.84

Burner Electrode

This part has a male spade and helps your burner ignite and produce flame. If a wire lead is needed, you can purchase locally.

$2.70

Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$38.09

Burner Head with Electrode

$35.15

Burner Head

This part includes the spark igniter.

$3.83

USE WPL 74009421

$30.05

Burner Head with Electrode - Small

$28.17

Burner Cap - 6000 BTU

$57.05

Burner Cap - Large

$37.62

SWITCH- BU

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor stopped working on gas cooktop

  • Customer: Jeff from Lake Orion MI
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 41 of 41 people found this instruction helpful
As others reported, there are 2 torx screws that need to be removed so that the burner element can be removed. One came out with a little effort, the other one did not as it was corroded. After breaking a torx bit, a second torx bit succeeded in breaking off the screw head. This then required a drill to drill out the broken shaft and then rethreading the s... read more

The ceramic insulator on the burner ignitor cracked & the spark shorted so that the burner would not ignite.

  • Customer: Loren from San Luis Obispo CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 22 of 24 people found this instruction helpful
Firts I removed the 2 screws that held the burber in place. Then I lifted the burner up & disconnected the wire that connected to the ignitor. Then I removed the one screw that held the ignitor to the burner. I then reversed these steps, replacing the cracked ignitor with the new one, replaced the screw holding it to the burner, then reconnected wire, return... read more

Cracked porcelain insulator on burner ignitor

  • Customer: chad from Houston TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 10 people found this instruction helpful
Removed grate and burner cover (held on by gravity - no tools needed) then removed the two screws holding down the burner itself. These screws are Torx screws so you will need a Torx bit set (looks like a phillips head screw driver but is star shaped). Once these screws are out, the burner lifts off to reveal two phillips head screws holding the ignitor in... read more