Models > JES9800AAQ

JES9800AAQ Jenn-Air Range - Overview

Get Parts and Repair Help for JES9800AAQ

If you know the range repair part you need, you can browse the list of all parts on the JES9800AAQ, or you can search by name or part description. You can also find your part by where it is located on the JES9800AAQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JES9800AAQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$27.04

Bake Element

This bake element has push-on terminal ends.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$15.25

Grease Filter

The filter is made of metal and is intended for use with ranges and cooktops. As per the manufacturer, if this filter is 1/2" less wide than the original, it will still function th...

$3.76

Levelling Leg

This leg is sold individually.

$2.70

Screw

This screw is sold individually.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$32.11

Door Gasket

This oven door gasket comes with built in retaining clips.

$58.06

Infinite Switch

This part is used for the 6" and 8" burners. 240V

$39.64

Dual Surface Burner Switch Kit

This switch is used to operate the dual surface burner.

$17.20

Terminal Block

It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H. OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 468 of 469 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

The element broke in two pieces after food dried on it.

  • Customer: Heather from Huntsville AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 78 of 79 people found this instruction helpful
First, I unplugged the oven. Then, I removed the two screws that hold the element in place. After that, I gently pulled the element toward the front of the oven until the wires were exposed. I disconnected the wires from the old element, removed the old element and then attached the wires to the new baking element. I gently pushed the new element back in... read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 70 of 79 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more