Models > JES0601T01

JES0601T01 General Electric - Overview

Parts and Repair Help for models starting with JES0601T01

If you know the repair part you need, you can browse the list of all parts for models starting with JES0601T01, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with JES0601T01

$19.43

Secondary Door Switch

$5.55

Ceramic Fuse - 15 Amp

$23.50

Thermostat Cut-Out

Also known as Thermostat or Humidity Sensor for Fault Code.

$63.21

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$2.79

SCREW WASHER

$2.42

PIN FOOT

DISCONTINUED

$9.20

HOLDER-FUSE

DISCONTINUED

DISCONTINUED

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 81 of 100 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more

Oven would not power up

  • Customer: Andras from Lexington MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 24 of 30 people found this instruction helpful
There are 4 thermostats (aka TCO = Thermal Cut Out) in the GE JVM1440BH04
The schematic is under the cover in a black envelope to the top left of the unit if you face the door.

Check the fuse first. You can remove the front grate, then the numpad on the right. The fuse is right behind it. It's a 250V 20A Class F fuse.

There are fo... read more

Turntable won't move, no heat -but light and fan ok.

  • Customer: Sean from San Jose CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 18 of 21 people found this instruction helpful
Remove the 2 Torx-15 screws at left of control panel. Work the control panel out by pulling slightly to the left first - it is engaged to the slotted holes to the right.

Remove the door's upper switch by lifting the tab and pulling out the switch carefully. To install the new switch, you may have to remove 2 philips screws holding the plastic asse... read more