JED8430BDS Jenn-Air Cooktop - Instructions

removed motor, saw that stablizers were broke and went to a local parts supply shop called SUNDBERG and was given a price of about 49.00 for three stablizers. at that point i went to the internet and found PARTSELECT.COM were i found the same parts for a fraction of the price,17.00, i could not believe it! SUNDBERG customer service was horrible.PARTSELECT custormer service is great and was just over the internet,any how the repair is done no more loud noise and wife is happy again ,for awhile.thanks keep up the good work.i tell everybody about you guys.

Just placed new filter in slot

Simply removed old knob and replaced.

I used needle nose pliers to remove the broken piece then pushed the new knob on!!

very easy slip in

Opened the top section of the stove. Re-routed wires to be connected from the speed control device into the new cord. And done. Put everything back thogether.

just needed clearner for the top of my glass top, the operator was very helpful I received my clearniner in 7 days thank you

Took off the old one, put all new ones on.

This Jennifer-Air cooktop has a black Schott Ceran surface. I unplugged the unit and disconnected the vent duct then removed the unit from the cabinet and shifted it 90 degrees to gain access to 10 screws that hold surface to body. Connections for replacement burner are slightly different than the original. I photographed wiring/connectors them removed the old burner. I removed mounting clips from old burner and installed them on the replacement (required two small tapping holes in aluminum case of replacement burner element). Installed new element and attached connectors (wires). No joy, outside element still did not heat - placed a dual element switch on order (have not received it yet). To be continued.

I carefully removed the disgusting old filter and took straight to trash. I then used my wet/dry vacuum to clean the rest of the loose debris from the area where the filter area is located. I used a clean, dry cloth to wipe the remainder of the material away and then carefully lowered the clean new filter down into it's new home. So easy, it took longer to type out these directions :)

Remove blower assy. Lift cook top. Remove side screws on cooktop to cooktop frame. Lift glass cook top. Replace fan switch. Reverse disassembly.

1. remove corlan cover from base of unit 2. study original wire pattern of old burner and switch; write down pattern on paper 3 gently remove wires with needle nose pliers.4 replace with new burner and switch with color coded wire pattern copying the original wiring 5 reinstall corlan cover on base. remember to shutdown cooktop from either circuit breaker or fuse in order not to electrocute yourself while working remember wires are live until shut down from main source of power

Part is a new design. Had to remove all the housing for the old knob. Don't leave anything in the hole. A bit apprehensive, but it works great.

Looked up the part on the internet. Found it with ease. The thing I did miss was that the switch had a small nub to keep it in the right place in the Glass top. The repair went easy. Probably took no more than 15 minutes. I would use PartSelect again.

Before installing the new part I made a metal coller to fit around the bottom of the stem. It gives the knobs the support that is lacking on the original part. I did this to all the knobs previosly and never had any more broken knobs.