Models > JE2160CF03

JE2160CF03 General Electric Microwave - Overview

Get Parts and Repair Help for JE2160CF03

If you know the microwave repair part you need, you can browse the list of all parts on the JE2160CF03, or you can search by name or part description. You can also find your part by where it is located on the JE2160CF03 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE2160CF03 [Viewing 1 of 1]

$18.36

Roller Guide

$56.18

Cooking Tray

$8.11

Light Bulb and Socket

This light bulb is sold with the socket. The bulb is 120V and 25W.

$7.52

SWITCH MON.

$38.45

Turntable Motor

$109.34

Magnetron

This part is used to generate microwave energy/heat.

$7.77

Micro Switch

$56.18

Primary/Secondary Switch

This is one switch - appliance would need 2.

$9.75

THERMOSTAT MAGNETRON

$2.42

FOOT

Common Symptoms of the JE2160CF03 [Viewing 1 of 44]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Original lamp burned out.

  • Customer: Rudy from Huntington IN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 32 of 41 people found this instruction helpful
After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece.
Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection.
Job was complete after reinsta... read more

The turntable would not turn, and made a clicking sound

  • Customer: Dave from Danville CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
Thanks to great instructions from a previous person, this was super easy. It took 5 minutes to remove and replace the new motor. The big part of this job was cleaning out the cabinet where the microwave sits, since I had to take it out.

There is a 'door cover' pressed into the bottom of the microwave, that just has 6 small tabs that you need to cu... read more

Both Intermittent- and No-Heating

  • Customer: Richard from Merritt Island FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 4 of 4 people found this instruction helpful
First, I read the PartsSelect DIY report by Linda, Warsaw, IN. With confidence, I purchased the magnetron. Upon receipt, I took the built-in microwave out of the cabinet, set the unit on the kitchen floor, and was stopped cold by the Safety Torx nuts on the reverse of the unit. Borrowing the right wrench allowed the 20 minute start-to-finish part changeou... read more