Models > JE1860SB01

JE1860SB01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1860SB01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1860SB01, or you can search by name or part description. You can also find your part by where it is located on the JE1860SB01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1860SB01 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.05

Line Fuse

Order within the next 8 hrs and your part ships today!
$58.73

Glass Cooking Tray

This tray rotates in your microwave ensuring more even temperatures.

Order within the next 8 hrs and your part ships today!
$3.21

Plastic Rivet

Plastic

Order within the next 8 hrs and your part ships today!
$28.63

2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

Order within the next 8 hrs and your part ships today!
$27.55

Monitor Switch

Order within the next 8 hrs and your part ships today!
$24.57

Waveguide Cover

Order within the next 8 hrs and your part ships today!
$14.95

Diode Cable

Order within the next 8 hrs and your part ships today!
$5.98

BOARD LATCH

Order within the next 8 hrs and your part ships today!
$24.98

CAPACITOR HIGH VOLTAGE

Order within the next 8 hrs and your part ships today!
$8.33

COVER STIRRER FAN

Order within the next 8 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 393 of 511 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

Microwave would turn on and count down, but not heating and not rotate turntable. Pressing door up would occasionally start heat.

  • Customer: Michael from Ridgefield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 23 people found this instruction helpful
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reconnect wires, reseat... read more

element sparking, damaged cover

  • Customer: Deborah from Ennis TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 12 of 13 people found this instruction helpful
2 plastic tabs held the waveguide in. They had to be pried out with the butter knife. Once they were out, the old cover came out and the new cover slipped in place. the tabs were a little tricky to get back in, but not too difficult. read more