Models > JE1860CB01

JE1860CB01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1860CB01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1860CB01, or you can search by name or part description. You can also find your part by where it is located on the JE1860CB01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1860CB01 [Viewing 1 of 1]




Glass Cooking Tray

This tray rotates in your microwave ensuring more even temperatures.


Plastic Rivet



2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.


Monitor Switch



This part is used to generate microwave energy/heat.


Waveguide Cover


Diode Cable





Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 349 of 462 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.


The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

I diagnosed the problem incorrectly: based on a previous repair.

  • Customer: Ralph from Brandon FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 27 of 59 people found this instruction helpful
The old fuse is perfectly good. The new ones arrived within a day. read more

element sparking, damaged cover

  • Customer: Deborah from Ennis TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 12 of 13 people found this instruction helpful
2 plastic tabs held the waveguide in. They had to be pried out with the butter knife. Once they were out, the old cover came out and the new cover slipped in place. the tabs were a little tricky to get back in, but not too difficult. read more