Models > JE1590BH02

JE1590BH02 General Electric Microwave - Overview

Get Parts and Repair Help for JE1590BH02

If you know the microwave repair part you need, you can browse the list of all parts on the JE1590BH02, or you can search by name or part description. You can also find your part by where it is located on the JE1590BH02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1590BH02 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.05

Line Fuse

$53.39

Glass Cooking Tray

There are two different couplers (also known as a turntable shaft) that can be used for this tray - a male D-shaped shaft and a female D-shaped shaft. The couplers are sold separately.

$18.94

Primary Door Interlock Switch

This interlock switch is located in the door latch.

$14.52

Oven Lamp

$28.63

2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave en...

$25.41

Turntable Guide With Rollers

This roller guide sits underneath the glass turntable tray.

$27.55

Monitor Switch

$6.62

Turntable Coupler

$119.16

Magnetron

This part is used to generate microwave energy/heat.

$14.95

Diode Cable

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 402 of 520 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

Bulb Replacement

  • Customer: Donald from San Marcos CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 26 of 29 people found this instruction helpful
Remove shroud . Two black philips head screws on side, and several on the back side. The two bottom screws on the back are special screws that a philips,straight slot, or hex screwdriver will not remove. I took a dremel tool with a thin metal grinding disc and created a straight slot through the centr of the two bottom screws. This allowed their removal with... read more

Microwave would turn on and count down, but not heating and not rotate turntable. Pressing door up would occasionally start heat.

  • Customer: Michael from Ridgefield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 23 people found this instruction helpful
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reconnect wires, reseat... read more