Models > JE1340WB01

JE1340WB01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1340WB01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1340WB01, or you can search by name or part description. You can also find your part by where it is located on the JE1340WB01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1340WB01 [Viewing 1 of 1]

$6.62

FUSE

$39.30

Glass Cooking Tray

$3.00

Plastic Rivet

Plastic

$26.89

2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

$25.84

Monitor Switch

$14.09

Diode Cable

$9.95

Waveguide Cover

Also known as Canopy Mica or Magnetron Cover.

$26.78

Flame Sensor Thermostat

$76.23

High Voltage Capacitor

$2.79

BUTTON SPRING

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 305 of 399 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

I diagnosed the problem incorrectly: based on a previous repair.

  • Customer: Ralph from Brandon FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 24 of 54 people found this instruction helpful
The old fuse is perfectly good. The new ones arrived within a day. read more

Microwave would turn on and count down, but not heating and not rotate turntable. Pressing door up would occasionally start heat.

  • Customer: Michael from Ridgefield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 16 people found this instruction helpful
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reconnect wires, reseat... read more