Models > JE1340GA01

JE1340GA01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1340GA01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1340GA01, or you can search by name or part description. You can also find your part by where it is located on the JE1340GA01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1340GA01 [Viewing 1 of 1]


Glass Cooking Tray


2-Terminal Micro-Switch

Also known as Interlock Switch. Appliance normally takes 2 of these. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.


Plastic Rivet



Monitor Switch


Light Bulb - 125V 20W


Diode Cable




Waveguide Cover

Also known as Canopy Mica or Magnetron Cover.





Common Symptoms of the JE1340GA01 [Viewing 1 of 21]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave would turn on and count down, but not heating and not rotate turntable. Pressing door up would occasionally start heat.

  • Customer: Michael from Ridgefield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 12 of 18 people found this instruction helpful
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reconnect wires, reseat... read more

bulb out

  • Customer: Oran from Chesapeake VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 18 people found this instruction helpful
The most difficult thing was removing the star security screws Both Home Depot and Lowes have tools to do this. The repair was a piece of cake, may have taken 15 min. Unplug 120v, remove case, bulb, replace and reassemble. GE doesn't want consumers fooling around inside the case, so be careful. read more

Microwave would not come on when plugged in.

  • Customer: Brian from Ridgway CO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 7 of 8 people found this instruction helpful
Removed chassis cover, traced power (hot good through fuse), neutral was interrupted though at the flame sensor. Replaced flame sensor. Replaced chassis cover, microwave works. read more