Models > JE1250WY01

JE1250WY01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1250WY01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1250WY01, or you can search by name or part description. You can also find your part by where it is located on the JE1250WY01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1250WY01 [Viewing 1 of 1]

$19.43

Secondary Door Switch

$18.81

Oven Cavity Thermal Cut Out

Also known as a Sensor or Fuse. This part will trip once the inside of the cavity overheats and exceeds the recommended temperature.

$2.79

Spring - Button

$63.21

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$35.04

Turntable Drive Motor

$18.57

Thermostat

$27.77

COUPLER

$16.45

FUSE

$10.64

LAMP INCANDESCENT 40W

$219.11

SMARTBOARD

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 78 of 96 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more

Microwave dead--no LEDs lit on front panel

  • Customer: Steve from Redmond WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 22 of 28 people found this instruction helpful
Removed microwave from enclosure and removed cover, hoping it was as simple as a blown fuse. Found extremely helpful diagnostic sheet thoughtfully provided by manufacturer in an envelope affixed to top of cavity. Fuse was fine, but tracing the power feed into the machine revealed that the oven cavity thermostat was open--no continuity across it, and the diag... read more

Turntable won't move, no heat -but light and fan ok.

  • Customer: Sean from San Jose CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 18 of 21 people found this instruction helpful
Remove the 2 Torx-15 screws at left of control panel. Work the control panel out by pulling slightly to the left first - it is engaged to the slotted holes to the right.

Remove the door's upper switch by lifting the tab and pulling out the switch carefully. To install the new switch, you may have to remove 2 philips screws holding the plastic asse... read more