Models > JE1223L01

JE1223L01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1223L01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1223L01, or you can search by name or part description. You can also find your part by where it is located on the JE1223L01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1223L01 [Viewing 2 of 2]

$18.81

Oven Cavity Thermal Cut Out

Also known as a Sensor or Fuse. This part will trip once the inside of the cavity overheats and exceeds the recommended temperature.

FOOT

$14.09

BRN 20A FUSE

$2.66

BULB-OVEN

$82.23

GLASS TRAY

$59.37

HV RECTF ASM

$28.63

TEMPA FUSE

DISCONTINUED

$268.23

DOOR ASM

$196.05

OUTER CASE

Common Symptoms of the JE1223L01 [Viewing 1 of 52]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave dead--no LEDs lit on front panel

  • Customer: Steve from Redmond WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 24 of 30 people found this instruction helpful
Removed microwave from enclosure and removed cover, hoping it was as simple as a blown fuse. Found extremely helpful diagnostic sheet thoughtfully provided by manufacturer in an envelope affixed to top of cavity. Fuse was fine, but tracing the power feed into the machine revealed that the oven cavity thermostat was open--no continuity across it, and the diag... read more

while cooking a big dish of food, the microwave just stopped and went black

  • Customer: Mark from South Jordan UT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 8 people found this instruction helpful
Fortunately, my brother-in-law suggested it might be the "cut out" switch. After unplugging the microwave, I opened it up and identified one of two cut outs and removed the wires from each side of the cut out. To test if that was the problem, I connected the two wires together, bypassing the cut out. When I plugged the unit back into the wall socket, the ... read more

When running a burning plastic smell coming from the venting air.

  • Customer: Paul from Modesto CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 8 people found this instruction helpful
Took the cover off (removed the five screws, two of which were security screws off the back) and found one connector on the thermal cut out with its shielding melted. Very easy swap out of the new cut out and we were up and running as if new. read more