Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JDS9860AAW

JDS9860AAW Jenn-Air Range - Overview

Get Parts and Repair Help for JDS9860AAW

If you know the range repair part you need, you can browse the list of all parts on the JDS9860AAW, or you can search by name or part description. You can also find your part by where it is located on the JDS9860AAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JDS9860AAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$16.43

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$66.33

Inner Door Glass Pane

Glass only.

$100.06

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$31.34

Door Hinge - Left or Right Side

Sold individually.

$90.21

Grill Grate

This grill grate is sold individually.

$5.15

Insulation

This strip of insulation is located within the oven door.

$4.47

Screw

This screw is sold individually.

$10.76

Urethan Foam Gasket

$4.94

BAND-MOTOR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H., OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 501 of 506 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

The element broke in two pieces after food dried on it.

  • Customer: Heather from Huntsville, AL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 123 of 126 people found this instruction helpful
First, I unplugged the oven. Then, I removed the two screws that hold the element in place. After that, I gently pulled the element toward the front of the oven until the wires were exposed. I disconnected the wires from the old element, removed the old element and then attached the wires to the new baking element. I gently pushed the new element back in... read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 105 of 121 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more