Models > JDB1100AWS > Instructions

JDB1100AWS Jenn-Air Dishwasher - Instructions

All installation instructions for JDB1100AWS parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the JDB1100AWS
301-315 of 344
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

broken silverware basket

  • Customer: Janet from Norwood MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
This replacement basket fit perfectly, is well made, and came speedily, as promised!

Silverware basket was broken

  • Customer: Jack from Leesburg VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Take out old basket throw it away. Put in new basket. time: 20 seconds. It took longer to open the package. I'm guessing at the brand, and I'm not going to my other house to find out.

Not cleaning top rack

  • Customer: JOSEPH from ST. LOUIS PARK MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
After installing a new filter, :( I tried this. I wish I would have done this first since it's way cheaper and easier!!! If your dishwasher slowly starts to decline in its ability to clean the dishes, it's probably this problem.

The old silverware basket started cracking and coming apart after 5 years or so.

  • Customer: Brian from St. Louis MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I opened the door of the dishwasher, pulled out the old silverware basket, and then placed the new silverware basket where the old one was. The whole time, I was imagining how much it would be to call up and appliance repair guy and have him do this.

Replace silverware basket.

  • Customer: Jerry from Lubbock TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Lifted old one out. Set new one in.

Plastic wheels on lower rack of dishwasher broke

  • Customer: Mary from Felton CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Replaced the wheels with new ones I purchased from Parts Select. They just snapped right on. I will definitely use Parts Select again for any future items I need. The service was very fast and parts are marked at a reasonable price.

Basket Tray wore out on bottom and silverware would not hold.

  • Customer: Suzanne from South amboy NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I just opened the package, pulled out the baskets, separated them and put them directly in the dishwasher. The video showed the part and size of the baskets which was very helpful. The delivery was EXCELLENT!!! I would purchase from PartSelect again!

I needed a replacement silverware basket

  • Customer: Jillene from Green Bay WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I took the old one out of the dishwasher and put the new one in. The new one is much nicer and heavier than the original one!

Food chopper was broken.

  • Customer: Bob from Souderton PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
Followed video. Everything went together fine, but leaked water around motor shaft seal. Read comments section on video and someone had the same problem. I had pushed the seal into base too deep. I pulled it out and reseated it. It worked without leaking after that. Bob

lime up

  • Customer: myron from Indianapolis IN
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
took inside front off disconnect wires pull old unit out and put new unit in then put inside front back on tighten screws was done unit works like a new machine

Start Button malfunction

  • Customer: Henry from Galesville WI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Dissassemble the door. Remove the control panel. Install the new panel and re-assemble the door. Make note of the orientation of the control panel plug on the circuit board. There isn't any indicator that the terminal strip is up-side down other than the new panel doesn't work.

Very little water getting into the machine, would not clean .

  • Customer: john from crisfield MD
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
First turn off power and water then Removed the two screws on the bottom plate, took the plate off. To remove the valve , I took one screw out of the bracket and just loosened the other,Pulled the valve out ,removed the water lines,then reused existing brass connection, put the hoses on the new valve then put it back together .Turned the water on checked for leaks, then closed it up..Turned the power on and it works great.....

Water was only filling once in a while with water

  • Customer: Timothy from WHITE CLOUD MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
my dishwasher is located in a island so i pulled the paneling off the back & the covers off the bottom of the dishwasher. my water shut off is under the dishwasher. i shut it off unhooked the water line at the union shut off the electric, unpluged the valve, pulled 4 screws out of the valve bracket , slide the clamp off the hose and removed the hose from the valve took the valve unit out removed the water line from the old valve put it on the new valve reassembled it turned water on checked for leaks turned the electric on and tried it out.

silverwear basket was cracked/

  • Customer: Marylou from Dana Point CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Just dropped it in and that was it.

Old basket worn, silverware falling through holes

  • Customer: Thomas from Washington PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Took old basket out, put new basket in
All Instructions for the JDB1100AWS
301-315 of 344