Models > JCTP70SM1SS

JCTP70SM1SS General Electric Oven - Overview

Get Parts and Repair Help for JCTP70SM1SS

If you know the oven repair part you need, you can browse the list of all parts on the JCTP70SM1SS, or you can search by name or part description. You can also find your part by where it is located on the JCTP70SM1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JCTP70SM1SS [Viewing 5 of 5]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.89

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$4.01

Oven Bulb Lens Cover - Glass

$17.09

Oven Light Housing

Must buy bulb locally as per manufacturer.

$26.89

Door Gasket

This oven door gasket prevents heat from escaping the oven cavity when in use.

$2.36

Single Screw Only

Sold Individually.

$2.79

Screw

Sold Individually.

$99.96

PACK WINDOW ASM

$1.70

Screw

This screw is sold individually.

$4.05

NUT

$2.79

SCREW-10AB

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 14 of 17 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

F2 error code

  • Customer: George from Fiskdale MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 7 of 9 people found this instruction helpful
After reviewing the potential causes for the error code, I decided I'd try to change out the temp sensor. Using the ohmeter, I saw the difference immediately between the old and new sensor. The sensor is accessed from the back of the stove, and must be slide out to gain access to the rear panel. Since the stove I have is a built in, removing the stove and... read more

Actual temperature did not match set temp

  • Customer: Brian from Fairfield CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
Removed the oven door for easy acces to oven. Unscrewed (philips screwdriver) the screw holding temp sensor in place. Gently pulled the wiring until quick connector was located. Pushed down on locking level on quick connect while holding other end of wiring (so wiring would not fall back behind oven). Connected the new sensor and screwed back in place. ... read more